Incense Bowl, Holder, Individual Sticks

Incense Bowl With Lit Incense

Incense Bowl

Incense Holder

Incense Stick / Lit Incense Stick

------------------------------------------------------------------------------
------------------------------------------------------------------------------

BLUEPRINTS:

Incense_Bowl_With_Lit_Incense_1711765463.blueprint

Incense_Bowl_-_Stone_1711765359.blueprint

Incense_Holder_-_Stone_1711766964.blueprint

Incense_Stick_1711764743.blueprint

Lit_Incense_Stick_1711764572.blueprint

------------------------------------------------------------------------------

NOTE: Individual incense sticks are oversized so they can easily be scaled for purpose.

Quote from angriff

is smoke coming off the lit stick?

I wish, but there's no particle effects generator in the game yet. The best I could do was add a small red/orange section to make it look like it was lit and then a gray ash section on top of that.

Quote from angriff

Oh I was hoping. Anyway, I have a statue with a fire embedded in it so just the smoke is seen (and a few sparks) so I can put a bunch of these around and it will look good. Thanks

Yeah unfortunately in this case the incense stick is just way too small to embed a fire into it.

there's a couple of things I've made and am planning to make that I'm designing to be able to use particle effect generators, block rotation, etc. in the future once Red gets it implemented. That should be able to be scaled down enough for this.

Quote from Avanar

I didn't try with objects but can't you shrink the fire, blueprint it and then struck it even more?

I think you can, I'll have to try it once I peel my eyes open, but I'm also 99% sure the particle effects are tied to the scale of the model. That's how we can scale down the fire to fit in a chimney and not have the smoke going through the sides of the chimney, but also means in this case it would be scaled too small to even see the smoke.

Quote from angriff

looks good with under the table smoke

nice