Control over inner diameter of hollow blocks

Is there a command to control the inner diameter of hollow blocks (hollow cylinder, torus, etc.)? I've been looking for it for a long time without success.

If not, it would be great to have one; it would open up many possibilities for creating some objects (dishes, mechanisms, etc.) or for simplifying those that currently require too many blocks.

Thanks Avanar and Yarofrey, I'm aware of this work around and I have used it very often.

I would like to be able to do without it, because it's very bad for optimization. Each time I used it, it's 6 block or often more, whereas I could only use one if I could control the internal diameter of the hollow blocks.

Edit :

Take, for example, this wagon wheel published in July 2024. It has 360 blocks; I find that far too many for this object. However, it's a focal point on a cart that has a significant impact on the overall perceived quality of the object, which is why I don't want to degrade the detail and I don't see how to optimize it without doing so. If I could control the internal diameter of the hollow blocks, this same object, with equivalent quality, would easily drop below 50 blocks, representing an improvement of at least a factor of 7.

So yes, this wagon wheel is a somewhat extreme example of the benefit of having control over this parameter, but it's a very real one.